Microlife BP3GX1-5A, Instruction Manual

Page: 17 / 63

16
5.3. Using the cuff
a) Pass the end of the cuff through the flat
metal ring so that a loop is formed. The
hook and loop material must be facing
outward. (Ignore this step if the cuff has
already been prepared.)
b) Slide the cuff onto your upper left arm. The
rubber tube should be on the inside of your
arm extending downward to your hand.
Make certain the cuff lies approximately
1/2” (1 to 2 cm) above the elbow.
IMPORTANT: The red strip on the edge of
the cuff (Artery Mark) must lie over the artery
which runs down the inner side of the arm.
TIP: Align red artery mark to pinky finger.
c) To secure the cuff, wrap it around your
arm and press the hook and loop material
together. Check the position of the green
SIZING SEAM on the cuff. Ensure green
sizing seam overlaps green size range bar.
d) There should be little free space between
the arm and the cuff. You should be able
to fit 2 fingers between your arm and the
cuff. Clothing must not restrict the arm.
Any piece of clothing which does must be
removed. Cuffs that don’t fit properly
result in false measurement values.
Measure your arm circumference if you
are not sure of proper fit.
½
”
8.7” - 16.5”