Specifications:
Amplifier:
Power output: 26 Watt + 14 Watt x 2 RMS (THD=1%)
Frequency response: 40 Hz - 20 kHz
Sensitivity Input: 350 mV
Distortion: < 0.3% (1 Watt 1kHz)
Separation: > 54 dB
S/N: > 75 dB
AC input: 120 V ~ 60 Hz 500 mA
Audio input:
iPod/iPhone Dock 30pin, AUX (Auxilliary),
RCA x 2 (Left & Right)
FM frequency modulation: 87.0 MHz - 108.0 MHz, Step frequency: 0.1 MHz
Driver units: 5.25" Subwoofer,
2.5" x 2 Satellites (magnetically shielded)
FAQ
It is abnormal while switching to
FM
Ensure the dock insert is of the correct iPod version
Remove the iPod from the interface and check for
obstructions on the connector and on your iPod. Then
reinsert the iPod.
*
*
Ensure the system is plugged to its AC source and the
power is ON
Check the iPod is ON and a music track is being played
Try pressing the Play/Pause button on the remote control
Increase the volume setting on the system
Ensure the Input selection is correctly set
Remove the iPod from the dock and the reseat it after a
period, you might have to this for few times. Could be an
interface positive connection problem
Ensure the iPod is running compatible software
*
*
*
*
*
*
*
Ensure the power cable is properly plugged to an AC wall
outlet
Ensure the iPod is properly inserted
*
*
·
iPod notes: Install the correct base type in accordance with the iPod version used
Remove your iPod from the dock and wait for 5 seconds before
reinserting it.
Unplug the power cable for 1 minute, then reconnect it and
power ON
*
*
Press the "MEMORY" button and then the "RESET" button
on the remote control. It will display correctly.
If the problem persist. please contact the vendor, or seek professional assistance.
*
1. Power ON/OFF switch
2. Fuse T500mA L250V
3. AC input
6. Bass Reflex tunnel
7. iPod Dock, 30 pins
4. Audio RCA sockets
5. FM antenna socket
ILLUSTRATIONS and OPERATIONS
3.
Depress the ST-BY button on the front panel or the remote control to bring the system to full power.
4.
Depress the INPUT selector to the mode to playback. The system will switch between AUX, FM or
iPod/iPhone.
5.
For media player or TV, please ensure this is turn on and playback is activated. Select the INPUT to AUX
6.
For iPod or iPhone, please dock it and start the music playback. Select the INPUT to iPod/iPhone. Use the
remote control to switch the songs and volume level.
7.
Adjust the volume knob on the front panel or remote control to your preferred listening level.
8.
For FM radio, select the INPUT to FM and tune to your favourite station. Use the + or - buttons on the front
panel or remote control to tune. Please position the antenna till the reception is clear.
- the end -
© 2011 Microlab Electronics Co., Ltd All rights reserved
T500mAL250V
5
80-MD332- 97-0001-05 2011-03-02 (unrelease)
80-MD332(11)-97-0001-01 2011-06-15
