Page 6
RS232 REMOTE CONTROL
The MIR540 can be controlled or queried by a computer or process
controller via the wired RS232 interface. The MIR540 uses a
simple protocol to communicate with the host system. An interface
manual is available on the MicroImage Video Systems website in
the MIR540 section at www.mivs.com.
IN CASE OF DIFFICULTY
If you are experiencing problems with any MicroImage product,
you can contact MicroImage Support using the following methods:
Phone
610-754-6800
Fax
610-754-9766
Web
www.mivs.com
Page 3
DESCRIPTION
The MIR540 is designed to reverse the video image in either the
horizontal, the vertical or both directions. Each input channel may
be independently mirrored. Mirroring in both directions is the
same as rotating the image 180 degrees.
The MIR540 will work with a variety of cameras or other video
sources, either Black & White or Color. The MIR540 accepts
composite video input signals and will operate with NTSC or PAL
video systems (switch selectable)
Board Level and OEM versions of this product are also available.
Please contact your dealer or MicroImage Video Systems for
additional information.
UNPACKING
The Video Mirror Controller package includes the following items:
MIR540 Video Mirror Controller unit
+5 VDC Regulated Universal Power Module
This operation manual
Please inspect all items carefully and report damaged or missing
items to your dealer or MicroImage Video Systems.
INITIAL SETUP
Before the unit can be used, it must be set up for the proper video
standard. This function is set with a DIP switch located on the rear
of the unit. Each switch is numbered and OFF is in the UP position
while ON is in the DOWN position. The following sections describe
how to set these switches properly.
