CFEWH SERIES 1-10
|
INSTALLATIoN
Manual ©2013
|
MicroHeat Technologies Pty ltd
07
06
Installation Locations – Options
These suggested options show how the unit can be fitted in three situations, covering bathroom, kitchen and
laundry.
Please note that the location and installation of the unit is not limited to the options shown here.
The CFEWH must be installed in a vertical position on an internal wall, or in an internal cupboard or space.
Pre-installation
Pre-installation
CFEWH SERIES 1-10
CFEWH SERIES 1-10
CFEWH SERIES 1-10
Hot Water OUT
Pressure
Limiting
Valve
Hot
Water
Faucet
Hot
Water
Faucet
Hot
Water
Faucet
Hot
Water
Faucet
Hot
Water
Faucet
Basin
Basin
Shower
Kitchen
Sink
Basin
Basin
Basin
Hot
Water
Faucet
Hot
Water
Faucet
Washing
Machine
Shutoff
Valve
Pressure
Limiting
Valve
Shutoff
Valve
Pressure
Limiting
Valve
Shutoff
Valve
Cold Water IN
Hot Water OUT
Cold Water IN
Hot Water OUT
Hot Water OUT Pre-set Temperature
Hot Water IN
Cold Water IN
Cold W
ater IN
NOTE: All options can be installed without
cold using Pre-set Temperature
Installation Checklist
Please read through this section before commencing installation, to ensure you are familiar with the
component parts and the fitting procedure.
This unit must be installed by:
A Licensed Electrician, ensuring installation conforms to all current electrical wiring standards.
A Licensed Plumber, ensuring installation conforms to all current plumbing standards.
The CFEWH must be installed in a vertical position on an internal wall, or in an internal cupboard or space.
If the safety rules or the instructions outlined in this manual are not followed correctly, the unit may not
operate properly and could cause damage to property, serious bodily injury and/or death.
MicroHeat nor its Distributors will be liable for any damages due to failure to comply with the installation and
operating instructions outlined in this manual or through improper use.
Improper use includes the use of this appliance to heat any liquid other than potable water within the
conductivity range specified in this manual. Refer to the Reference section – page 19.
IP Rating – The unit is rated as IP44. The appliance must be installed inside a dwelling or construction and should
not be exposed to splashing water, rain or any circumstance that will allow water to enter the outside cover.
Ambient Temperature – The unit is intended for internal installation and should not be installed in an
environment where there is a possibility of the ambient temperature dropping below 5°C.
IMPORTANT
Failure to comply with the installation and operating instructions or improper use voids the warranty.
Never remove the unit cover unless the electricity is turned off at the isolation switch or switchboard.
To reduce the risk of electric shock or injury to persons or property, please follow the installation
instructions carefully.
WARNINg
In accordance with AS 3498, this appliance will not deliver temperatures exceeding 50°C.
Water temperatures greater than 50ºC can cause scalding. Care should be taken with children
and people with limited sensory, physical, and/or mental capability.
There is no requirement in AS/NZS 3500.4 to fit a temperature limiting device if this water heater is
installed in any location other than in an early childhood centre, school, nursing home or a facility
for young, aged, sick or disabled people, where temperature limiting devices may be required.
NOTE
This appliance can also be fitted as a Tandem Hot Water Service.
Please refer to the Tandem Hot Water Service Guide for full information.
IMPORTANT
Where the ambient temperatures are likely to approach freezing – ie: less than 5°C – the unit must be
drained of water to prevent frozen water damage occurring.
Failure to comply with the installation and operating instructions or improper use voids the warranty.
