5. DMX-512 CONTROL CONNECTIONS
This fixture complies with international USITT DMX standards and can be used with either a 3 pin or 5 pin DMX
connector. Plug in the provided 3 pin XLR cable to the female 3-pin XLR output of your controller and the other side to
the male 3-pin XLR input of the LED COB100 PAR/RGBWA. To connect the units to DMX, you must daisy chain the
fixtures together as referred in the diagram below. Always end your DMX-512 connection with a DMX terminator.
For installations where the DMX cable has to run a long distance, or is in an electrically noisy environment, it is
recommended to use a DMX terminator. This helps in preventing corruption of the digital control signal by electrical
noise. The DMX terminat
or is simply an XLR plug with a 120 Ω resistor connected between pins 2 and 3,which is then
plugged into the output XLR socket of the last fixture in the chain. Please see illustrations below.
6. SETUP MENU
1
2
3
PIN 3
PIN 2
120
Ω
DISPLAYED
FUNCTION
D.001
DMX ADDRESS
SOUN.
SOUND ACTIVE
P0-0.
PRESET MACROS
CF-0.
COLOUR FADE
CC-0.
COLOUR CHASE
CS00.
COLOUR SELECTION
SLAU.
SLAVE
3
