3
- This unit has a total of 7 operating modes:
Master/Slave, Auto, DMX, Sound Active, Colour Fade, Colour Chase and
Static Colour.
MASTER/SLAVE MODE
- By connecting the 3 pin DMX, you can daisy chain up to 30 units on master/ slave mode. Daisy chain the fixtures
together by plugging from the DMX output of the first fixture into the DMX input of the second fixture, and so on…
- On your Master fixture set the unit to STATIC MODE, AUTO RUN, SOUND, COLOUR FADE or COLOUR CHANGE.
Press MODE button and set all slave lights to “SLAV” from the Main Menu. They will now run the same program that you
have selected on your master fixture.
AUTO-RUN MODE
Press MODE button and select “AUTO” mode. The colour change mode and the colour fade mode programs will run
alternatively. The running speed is the current speed of each individual program. You can adjust the amount of program
cycles by pressing the SET UP button. The display will show “n.XXX”, “XXX” representing the current number shown.
Pressing the UP and DOWN buttons to increase or decrease the amount 1-100 of program cycles.
DMX MODE
Press “MODE” button and select “d.X X X”. Press “UP” or “DOWN” to select desired DMX address. You can set up to 512
addresses. It will flicker when there is no controller signal.
SOUND ACTIVE MODE
Press “MODE” button and select “SU.XX”. Press “UP” or “DOWN” to select sound-active sensitivity grade 0-31. (0 is OFF,
1 is the lowest sensitivity, 31 is the highest sensitivity.)
COLOUR FADE MODE
Press “MODE” button and select “F3.XX”. Press “SET UP” button to select the three colour fade mode “F3.XX” or the
seven colour fade mode “F7.XX”, then press “UP” or “DOWN” to select the color fade speed grade 1-99 under this mode.
(1 is slowest, 99 is quickest)
COLOUR CHANGE MODE
Press “MODE” button and select “J3.XX”. Press “SET UP” button to select the three colour change mode“J3.XX”or the
seven colour change mode“J7.XX”, then press “UP” or “DOWN” to select the color change speed grade 1-99 under this
mode. (1 is slowest, 99 is quickest)
STATIC COLOUR SELECT MODE
Press “MODE ” button and select “CL-×”, Press “UP” or “DOWN” to select static color 0-7 under this mode.
MANUALLY ADJUST FOCUS LENS
To manually adjust the zoom lens with the on board display, press and hold the “MODE” button (except under Slave and
DMX mode) for 6 seconds. The display will read “O.T.O.r.”, after a while, it will show the position “C.X.X.X.”. Range: 0-190
(0 is start,190 is terminal) Under this mode, you can adjust running position of electrical machine by pressing “UP” or
“DOWN”. Hold “MODE” button to exit electrical machine adjustment. When the unit is turned off it will power back on in
the same position that it was set last.
