.05.
·
The moving head is for beam effect for on-site decoration purpose.
·
Don’t turn on the fixture if it’s been through severe temperature difference like
after transportation because it might damage the light due to the environment
changes. So make sure to operate the fixture until it is in normal temperature.
·
This light should be keep away from strong shaking during any transportation or
movement.
·
Don’t pull up the light by only the head, or it might cause damages to the
mechanical parts.
·
Don’t expose the fixture in overheat, moisture or environment with too much dust
when installing it. And don’t lay any power cables on the floor. Or it might cause
electronic shock to the people.
·
Make sure the installation place is in good safety condition before installing the
fixture.
·
Make sure to put the safety chain and check whether the screws are screwed
properly when installing the fixture.
·
Make sure the lens are in good condition. It’s recommended to replace the units if
there are any damages or severe scratch.
·
Make sure the fixture is operated by qualified personnel who knows the fixture
before using.
·
Keep the original packages if any second shipment is needed.
·
Don’t tr y to change the fixtures without any instruction by the manufacturer or
the appointed repairing agencies.
·
It is not in warranty range if there are any malfunctions from not following the
user manual to operate or any illegal operation, like shock short circuit, electronic
shock , lamp broke, etc.
OPERATION INSTRUCTIONS
5
Cautions:
For added protection mount the fixtures in areas outside walking paths,
seating areas, or in areas were the fixture might be reached by unauthorized
personnel.
Before mounting the fixture to any surface, make sure that the installation area can
hold a minimum point load of 10 times the device’s weight.
Fixture installation must always be secured with a secondar y safety attachment, such
as an appropriate safety cable.
INSTALLATIONS
6
