13
5
Installation
Follow any applicable regulations when installing the Energy Pak.
The Energy Pak must be turned OFF during installation. Avoid touching the battery terminals. Do not place
any objects on top of the Energy Pak. Do not sit, stand or lean on the Energy Pak.
1. Selecting your location
The Energy Pak should be installed in a dry area that is free from moisture. Do not install this product in
locations where flooding may occur. Install the Energy Pak as close as possible to the charger, inverter and/or
electrical loads to minimize power losses in the cables.
If installing on a concrete floor, it is recommended to place the Energy Pak on an insulating pad to prevent
the cold temperature of the floor from affecting battery performance.
Unlike some types of AGM batteries, ventilation is not required. The Energy Pak does not discharge toxic
chemicals or vapours.
Do not install in compartments containing flammable materials or in locations which require ignition-
protected equipment. This includes any space containing gasoline-powered machinery, fuel tanks, or joints,
fittings, or other connection between components of a fuel system.
2. Proper orientation
It is best to place the Energy Pak in the upright position, i.e. with all labels oriented horizontally. Placing the
Energy Pak on its side is permitted but not recommended. Never place the Energy Pak upside down - this
could lead to the battery cells detaching from the bottom of the chassis, which can then lead to short circuits.
Secure the Energy Pak with fasteners after installation, especially if it is being used in a moving vehicle such as
a boat or RV. This is especially applicable to the Energy Pak 3 and Energy Pak 6; note that the casing contains
holes which enable them to be fastened down with screws; use screws of an appropriate strength and fasten
them to fixtures capable of supporting the weight.