Microgate WITTI-TAB, User Manual

Page: 29 / 33

Microgate Witty TAB User Manual Page 29 of 33
2.15 P14 – L
AP
T
IME
This program allows you to display the Lap times. The run time is automatically starting on the first
received impulse and for each subsequent impulse the lap time is calculated and displayed based
on the previous impulse.
To stop and reset the run time press L
AP
-R
ESET
.
2.16 P15 - W
ITTY
·
SEM
This program allows to combine the use of the Witty·SEM devices with the Witty·TAB by showing
the run time or counting the number of impulses. Within this program the Witty·TAB is acting
similar to a Witty·SEM: It receives the test configuration via radio from the Witty chronometer and
is auto-configuring itself by choosing the display mode depending on the test configuration.
The program is supporting the following test types of the Witty·SEM:
•
Change Direction : Shows the time between the first activation of the Witty·SEM to the
next impulse of a photocell.
•
Agility : In case the test has been configured with a timeout, but without limit of the
number of impulses, Witty·TAB is showing the number of impulses received from the
Witty·SEM. Otherwise it shows the run time and the lap time for each impulse.
2.17 P96 – P
HOTOCELL
F
ILTER
The photocell filter allows you to configure a filter to accept impulses from certain photocells only.
•
This filter gets reset every time this program gets activated and on startup of the
Witty·TAB.
•
To enable the filter: Activate this program and register all allowed photocells by
interrupting their light beam. The number on the display is showing the current number of
registered photocells.