Microframe Corp
Page 7
D8010 Manual r1.1
Setting Brightness:
There are two ways to set the brightness: “on the fly” and “in memory”.
-
To change the brightness “on the fly”, simply press the”+” or “-“ buttons when the display is on. You will see
the brightness change immediately. Brightness will remain at this setting until the battery is removed.
However, when the battery is removed and re-inserted the brightness will go back to the “in memory”
setting.
-
To change the “In memory” brightness press and hold “ON” and “-“ (minus) together when the display is on
to get into the options mode. The first option you will see is “SLEEP”. Press “ON” to scroll through options
until you see “brite” (the 4
th
option). From here, press “+” or “-“ to increment or decrement the brightness
and then press and hold “ON” to save. This new brightness setting will be used any time a new battery is
inserted.
Remember, the higher the brightness the shorter the battery life.
Set Flip Direction:
As a personal preference or for cable concerns, one may want to change the orientation
of the Sync Master to have the buttons on the right instead of on the left. This can be achieved by simply
changing the “Flip” memory location. Setting this memory location to “1” instead of “0” will change the
orientation of your display. Simply get to Options mode by pressing and holding “on” and “-“, the unit will show
“SLEEP”. Press the “on” button until you see the “FLIP” setting. Press “+” or “-“ to change this setting, hold “on”
to save. Note: the Frame count ends up on the top row. The “Flip Direction” option is not available on the
D8009, as that model is missing a digit.
Info Mode
To enter info mode, while the display is on, press and hold [+] and [-] buttons. Use the “ON” (mode) button to
toggle between options. Press and hold “ON” (Mode) to exit.
1)
Model and software revision.
2)
Battery voltage – can be used to gauge how fresh the battery is. This is affected by the display brightness.
Reset to Defaults
To reset to factory defaults, press and hold all three buttons while inserting the battery. The prompt “Reset 0”
will show on screen. Press [+] once to confirm, then press and hold [On].
