![MicroElektronika EasyPIC4 User Manual Download Page 24](http://html1.mh-extra.com/html/microelektronika/easypic4/easypic4_user-manual_1786333024.webp)
EasyPIC4 User
’
s Manual
2
24
4
page
M I K R O E L E K T R O N I K A S O F T W A R E A N D H A R D W A R E S O L U T I O N S F O R T H E E M B E D D E D W O R L D
MikroElektronika
Development
tools
The LCD must be placed in the marked position with two free pins to the left and
four free pins to the right. It is important to note that the LCD should be placed or
removed from EasyPIC4 only when the power is off. Before attaching the LCD, set
jumper JP12 to the left position. The LCD's contrast can be adjusted using poten-
tiometer P3 which is located to the right of the GLCD/LCD connector.
EasyPIC
ICD
4
LL
CC
DD
22
XX
11
66
II
NN
88
--BB
IITT
MM
OO
DD
EE
LCD 2X16 IN 8-BIT MODE
When using a character LCD in 8-bit mode, the connector that is shared with the
GLCD should be used. Since this connector has 20 pins and the character LCD has
only 14 pins, special attention is required when placing the LCD. Otherwise the
LCD can be permanently damaged.
Figure 33.
LCD 2x16 in 8-bit mode
NOTE:
Special attention is required when placing the LCD. Otherwise the LCD can
be permanently damaged.
View from the back:
shows which pins
stays disconnected.
2x16 LCD
2x16 LCD
2x16 LCD
CONNECTOR
2x16 LCD
CONNECTOR
ON-BOARD
ON-BOARD