Microchip Technology UCS1003-2, User Manual

Page: 18 / 30

UCS1003-2 Evaluation Board User’s Guide
DS50002430A-page 18

2016 Microchip Technology Inc.
2.1.6 Configuration for BC1.2 SDP Mode
The Standard Downstream Port (SDP) mode configures the UCS1003-2
Evaluation Board to close the high-speed switch and allow the USB to
enumerate. To configure the evaluation board for the SDP mode, follow these
steps:
1. Configure the jumper settings as shown in Table 2-5 .
2. Connect a cable from USB port J9 (USB-B) to an upstream PC USB port.
3. Apply 5V. The UCS1003-2 is set to the Active state and awaits a
downstream device to enumerate the USB upon attachment.
TABLE 2-5: UCS1003-2 EVALUATION BOARD JUMPER DESCRIPTION FOR SDP MODE
( 1 )
Jumper
Designator
Jumper
Position
Pin Name Function Description
J7 1-2 V
BUS
Jumper Placed = V
BUS
pins of the UCS connected to the V
BUS
of the
USB connector
J11 1-2 PWR_EN Jumper Open = Logic High: Port power switch enabled
3-4 EM_EN Jumper Open = Logic Low
5-6 M1 Jumper Placed = Logic High
7-8 M2 Jumper Placed = Logic Low
J12 2-3 SEL Jumper Placed = Logic High: PWR_EN is active-high
J13 15-16 ILIM Jumper Placed on Positions 15-16 and not placed on all the other
pins of the header J13: Current limit selection is set to 2.85A typical
(3A maximum)
J14 1-2 LATCH Jumper Placed = Logic Low: LATCH =
0
, auto-recovery enabled
3-4 S0 Jumper Open = Logic Low: S0 =
0
, Active mode
Note 1: The power source selection is not mentioned in this table. The headers that select the power supply
source (J5 and J8) must always have 2 jumpers populated on them in total. For more information, see
Section 3.1.1 “Power Source” .