Microchip Technology RN41, Manual

Page: 13 / 28


2014-2022 Microchip Technology Inc. DS50002280C-page 13
RN41/RN41N
3.0 REGULATORY APPROVAL
This section outlines the regulatory information for the
RN41/RN41N module for the following countries:
• United States
• Canada
• Europe
• Australia
• New Zealand
3.1 United States
The RN41/RN41N module has received Federal Com-
munications Commission (FCC) CFR47 Telecommuni-
cations, Part 15 Subpart C “Intentional Radiators”
modular approval in accordance with Part 15.212 Mod-
ular Transmitter approval. Modular approval allows the
end user to integrate the RN41/RN41N module into a
finished product without obtaining subsequent and sep-
arate FCC approvals for intentional radiation, provided
no changes or modifications are made to the module
circuitry. Changes or modifications could void the
user’s authority to operate the equipment. The end
user must comply with all of the instructions provided
by the Grantee, which indicate installation and/or oper-
ating conditions necessary for compliance.
The finished product is required to comply with all appli-
cable FCC equipment authorizations regulations,
requirements and equipment functions not associated
with the transmitter module portion. For example, com-
pliance must be demonstrated to regulations for other
transmitter components within the host product; to
requirements for unintentional radiators (Part 15 Sub-
part B “Unintentional Radiators”), such as digital
devices, computer peripherals, radio receivers, etc.;
and to additional authorization requirements for the
non-transmitter functions on the transmitter module
(i.e., Verification, or Declaration of Conformity) (e.g.,
transmitter modules may also contain digital logic func-
tions) as appropriate.
3.1.1 LABELING AND USER
INFORMATION REQUIREMENTS
The RN41/RN41N module has been labeled with its
own FCC ID number and if the FCC ID is not visible
when the module is installed inside another device,
then the outside of the finished product into which the
module is installed must also display a label referring to
the enclosed module. This exterior label can use word-
ing as follows:
RN41:
Contains Transmitter Module FCC ID: T9JRN41-3
or
Contains FCC ID: T9JRN41-3
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation
RN41N:
Contains Transmitter Module FCC ID: OA3-RN41N
or
Contains FCC ID: OA3-RN41N
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation