2
Procedure
Verification of Calibration
Prior to operating the device, please ensure the device is in a working condition. Visit the
following website to verify your Silicon Sculptor 4 is calibrated and ready to use:
.
Setup
1. Download SculptW software from
https://www.microsemi.com/product-directory/
programming/4979-silicon-sculptor
.
2. Follow on-screen instructions to install SculptW software and restart your PC.
3. Provide power to the site by connecting the provided external 24 V switching power supply. The
programmer requires the input voltage to be accurate within ±5% to be operational. Confirm that
the power supply is rated at least 90 W and 3.75 A. If the accompanying power supply is lost or
damaged, contact Microsemi for a replacement. Using an incompatible power supply may cause
damage to the programmer.
4. Directly connect the USB cable to type B USB port on back of programmer.
5. Directly connect the USB cable to type A USB port on PC. See the on-screen information to verify
the driver installation.
IMPORTANT!
The Found New Hardware Wizard launches for each individual programming site. You must
repeat a USB driver installation for each programming site. After installing the USB drivers, the PC
recognizes that the site(s) are connected at a later time. If a different USB port on the PC is used,
the Found New Hardware Wizard launches and installs new USB drivers.
6. After the USB driver installation, click
Finish
.
Silicon Sculptor 4
Quickstart Card
