Microchip Technology MCP19114, User Manual

Page: 19 / 36

MCP19114 - FLYBACK
STAND-ALONE EVALUATION
BOARD USER’S GUIDE

2014 Microchip Technology Inc. DS50002255A-page 19
Chapter 3. Graphical User Interface (GUI)
3.1 INTRODUCTION
The MCP19114 - Flyback Stand-Alone GUI requires a Windows
®
XP/7/8 operating
system, a USB port and a minimum screen resolution of 1024 x 768. To run the
software, follow the steps described in this section.
1. Apply an input voltage in the normal operating range (8V to 14V) at the V
IN
and
Ground test points.
2. Connect the PICkit Serial Analyzer to the PC via USB port and then connect the
analyzer to the Control Board via the 6-pin serial connector J5 (
Figure 3-1 ).
FIGURE 3-1: PICkit Serial Analyzer Connection to the Board.
3. To start the GUI, select Start > All Programs > Microchip Technology
Inc. > MCP19114 Flyback Standalone GUI . The interface detects the
MCP19114 device automatically and is ready for use (see Figure 3-2 ).