Microchip Technology EVB-UTC2000-UFP, User Manual

Page: 20 / 35

UTC2000 Evaluation Kit User’s Guide
DS50002399B-page 20

2015 Microchip Technology Inc.
3.1.4 Connector Descriptions for EVB-UTC2000-DFP
Table 3-3 describes the connectors included on the EVB-UTC2000-DFP.
3.1.5 Test Points on EVB-UTC2000-DFP
Table 3-4 describes the test points included on the EVB-UTC2000-DFP. A header may
be permanently installed on the through-hole test points if needed.
3.1.6 LED Indicators for EVB-UTC2000-UFP
Table 3-5 describes the LED indicators included on the EVB-UTC2000-UFP.
TABLE 3-3: CONNECTOR DESCRIPTIONS
REF. DES. TYPE LABEL DESCRIPTION
J1 1x5 Header - 5-pin debug header (internal MCHP use only)
J2 USB 3.1
Type-A Plug
- Type-A male plug
J3 USB 3.1
Type-C
Receptacle
- Type-C receptacle
FIGURE 3-6: EVB-UTC2000-DFP CONNECTOR LOCATIONS
USB Type-A Plug USB Type-A Plug
USB
Type-C™
USB
Type-C™
1x5 Debug Header
1x5 Debug Header
TABLE 3-4: EVB-UTC2000-DFP TEST POINT DESCRIPTIONS
REF. DES. TYPE DESCRIPTION
TP1 Thru-Hole 5V probe point or external 5V supply point
TP2 Thru-Hole GND
TABLE 3-5: EVB-UTC2000-UFP LED INDICATOR DESCRIPTIONS
REF.
DES.
LABEL DESCRIPTION
D1 “VBUS IN” Indicates that a valid VBUS (5.5V-4.0V) is being supplied to the
EVB-UTC2000-UFP from the USB Type-C™ connection and that
5V is being passed to the USB Type-A receptacle.
D2 “3A” Indicates when a 3.0 A capable DFP connection is detected.
D3 “1.5A” Indicates when a 1.5 A capable DFP connection is detected.
D4 “Legacy” Indicates when legacy 500 mA (USB 2.0)/900 mA (USB 3.1) capa-
ble DFP connection is detected.