HV2916 ANALOG SWITCH
EVALUATION BOARD
USER’S GUIDE
2021 Microchip Technology Inc.
DS50003160A-page 13
Chapter 2. Installation and Operation
2.1
GETTING STARTED
The HV2916 Analog Switch Evaluation Board is fully assembled and tested. The board
requires five power supply voltage rails: +5V for HV2916 and +3.3V,+10V and ±100V
for the pulser.
2.1.1
Additional Tools Required for Operation
1. An oscilloscope with a minimum of 500 MHz bandwidth and two high-impedance
probes. Make sure the grounds of the power supply sources are correctly
connected to the same ground as the testing oscilloscope ground.
2. A Microchip HV MUX Controller Board (ADM00825)
3. A Microsoft
®
Windows
®
7 or higher PC with the HV MUX Controller Board GUI
software installed and running
4. J1 and J2 connected to the HV MUX Controller Board
5. HV MUX Controller Board connected through the USB port to the PC
2.2
HV MUX GUI INSTALLATION
The HV MUX GUI software installer can be downloaded from the Microchip website at
www.mircochip.com
. Search for the evaluation board on the website by the part
number:
EV07D36A
.
1. Open the
HVMUXGUI-v1.0.0-windows-installer.exe
.
2. Initiate the HV MUX GUI software installer by launching the Application Install
dialog box.
