Using dsPIC30F Devices
©
2006 Microchip Technology Inc.
DS70099D-page 23
2.6.3
Enable MPLAB ICD 2 Connection
1.
From the Debugger menu, click Select Tool>MPLAB ICD 2 to designate the
MPLAB ICD 2 as the debug tool in MPLAB IDE.
2.
From the Debugger menu, select Connect to connect the debugger to the device.
The MPLAB ICD 2 should report that it found the dsPIC30F6014A device, as
shown in Figure 2-12.
FIGURE 2-12:
ENABLING MPLAB
®
ICD 2
3.
From the Debugger menu, click Settings to display the MPLAB ICD Debugger
settings.
4.
Select the Program tab.
5.
Check Allow ICD 2 to select memories and ranges, as shown in Figure 2-13.
This setting will speed up operations by programming only a small part of the
total program memory.
Note:
MPLAB IDE may need to download new firmware if this is the first time the
MPLAB ICD 2 is being used with a dsPIC30F device. Allow it to do so. If
any errors are shown, double click the error message to get more
information.
Status shows that target
device has been found
.
