Figure 4-2. Attaching Pin-Headers to the Curiostiy Nano Board
Figure 4-3. Connecting to Curiosity Nano Base for Click boards
™
Tip:
Start at one end of the pin-header and gradually insert the header along the length of the board.
Once all the pins are in place, use a flat surface to push them in.
Tip:
For applications where the pin-headers will be used permanently, it is still recommended to solder
them in place.
Important:
Once the pin-headers are in place, they are hard to remove by hand. Use a set of pliers and
carefully remove the pin-headers to avoid damage to the pin-headers and PCB.
4.2
Peripherals
4.2.1
Target USB Connector
Micro USB connector to develop USB Device application using the integrated USB peripheral on the
PIC24FJ64GU205
4.2.2
LED
There is one yellow user LED available on the PIC24FJ64GU205 Curiosity Nano board that can be controlled by
either GPIO or PWM. Driving the connected I/O line to GND can also activate the LED.
Hardware User Guide
©
2021 Microchip Technology Inc.
User Guide
50003124A-page 25
