CAP1xxx Evaluation Board User’s Guide
2013 Microchip Technology Inc.
DS50002221A-page 29
4.12.1 Power States
Please refer to the device datasheet for details regarding the different power states. The software
switches work as follows:
The Standby switch toggles between the Standby and Fully Active states.
The Deep Sleep switch puts the device into the Deep Sleep state. To exit Deep Sleep, click
anywhere on the GUI to display the message shown in
. There is also a timeout that
will display the message shown in
4.12.2 Configuration and Configuration 2
The Configuration section of 'Status and Control' allows the user to enable and disable bits in the
Configuration Register (20h). The Configuration 2 section allows the user to enable and disable bits in
the Configuration 2 Register (44h). These registers control the general global functionality of the
device. Refer to the datasheet for details.
Figure 4.17 Deep Sleep Message
Figure 4.18 Deep Sleep Timeout Message
