Figure 2-13. User Options Tabs
2.3
Advanced Modes
The AVR-IoT development board can be forced to enter one of a few advanced modes of operation at
start-up. These modes can be entered by pressing one or a combination of the push buttons that are
present on the board, labeled Switch 0 (SW0) and Switch 1 (SW1).
enumerates these
advanced modes, descriptions, physical indicators of entering a specific mode, and how to enter them.
Table 2-2. AVR-IoT WG Advanced Modes
Advanced Mode
Description
Instructions
Physical Indicators
Soft AP mode
Software-Enabled
Access mode enables
the WINC to be made a
wireless access point.
Press and hold SW0 at
power-up.
All lights are off
WINC OTA mode*
Enables over-the-air
WINC firmware updates.
Press and hold SW1 at
power-up.
Blinking Green LED
Bootloader mode*
Enables ATmega
bootloader.
Press and hold SW0
and SW1 at the same
time.
Blinking Red LED
* - Not implemented in firmware code version 1.00.
AVR-IoT WG User Guide
Chapter 2: Getting Started
©
2018 Microchip Technology Inc.
User Guide
DS50002809A-page 16
