13
/
32
washers of the fixed copper bar must be aligned parallel to the edge of the copper bar,
and the fixed screws must be tightened, otherwise the power board may be burned
out. , control board or power supply, hardware damage caused by copper stripping, is
not covered by the warranty.
（
2
）
The power control wiring between the control board and the power supply must
be connected. Otherwise, the power supply voltage output may not be controlled,
resulting in low power calculation.
（
3
）
The control board must be connected to the fan wiring reliably. If the fan wiring is
disconnected or the connection is poor, the miner may not be able to cool down, the
power board is down-converted, and the power is reduced.
5.Miner Data Configuration
（
Configuration on
the web page
）
5.1.Query the dynamic IP address obtained by the miner
5.1.1.Run WhatsMinerTools software
Miner data configuration PC Connect to the same network segment network where the
machine is located, run WhatsMinerTools software on the PC, select the “Detect IP” tab,
set the room number, rack number and layer number of the rack where the mining
machine is located. , the location number of the layer, click "Start".
