8
ssembly nstructions
5. Bevel the inside of the hose to allow the barbed portion of the
guncart to have an easier start into the poly tube. (
At this time,
slide the hose clamps onto the hose so they are in place and
ready to tighten after hose is connected.)
6. Heat the end of the poly hose to make it softer when inserting
the barbed portion of the cart. Only a small amount of heat
is needed. Do not overheat and melt the tube.
7. Take the cart in one hand and the poly hose in the other hand.
Insert the barb of cart into the hose while the tube is hot and
work in an up and down motion moving the poly hose onto
the barb.
8. Attach clamps with the bolt heads straight up on the
top
side of
the hose to allow clearance into the hose guide.
Summary of Contents for MR43
Page 1: ......