ICES model M series
Rev: M-20170706
( C ) 2017 Micro-Pulse
< SET >
SELECT PROTOCOL
- - B5 – C5 - -
< CHANGE > < SET >
POWER LEVEL = 9
[ - - - - - - ] 9
- - B5 – C5 - -
< CHANGE > < SET >
- - B5 – C5 - -
[ - - - - - - ] 9
- to reset: power OFF -
This is the start-up screen. This screen shows the model number, firmware
revision, and the copyright. The screen will display for 5 seconds then advance to
the next screen automatically unless you press the < SET > button (white button =
SET), which advances to the next screen immediately.
The next screen is the Power Adjustment screen. This screen shows the
power/intensity level as a power bar and number from 1 to 15. Below that it
shows the currently selected protocol name (in this case “B5 – C5”). You adjust the
power by pressing the white button <CHANGE>. With each press of the white
button, the power will reduce by 1 until it reaches power = 1, then it will jump back
and start from 15 again. As before, press the < SET > button (red button = SET),
which advances to the next screen immediately, or just wait 5 seconds.
This is the running screen. The green LED will flash every time a pulse is sent to the
coils. To reset the device or change the settings, turn the power OFF, then ON.
The next screen is the Protocol Selection screen. This screen shows the currently
selected protocol name (in this case “B5 – C5”). You can select a different protocol
by pressing the white button <CHANGE>. With each press of the white button, the
power will move down the list of protocols until it reaches the end, then it will
jump back and start from the beginning again. As before, press the < SET > button
(red button = SET) to run immediately, or just wait 5 seconds.
COPYRIGHT © 2017 Micro-Pulse LLC All Rights Reserved Worldwide
