5
1.2 Packing list of Accessories
1. Large wrench S:36
2. 1/2” Drill chuck & R8 shank
3. Oil can
4. Fixing pin
5. L hex wrench S:3,4,5,6
6. Spanner wrench D:45-52
7. Double end wrench 8-10,14-17, 17-19
8. Drill chuck holder
9. Handle
10. T-nut
11. Fuse 5A
12. Drawbar
1
1
1
1
4
1
3
1
2
2
1
1
2.1 Fundamental Machine Location
The machine should be bolted to a workbench to prevent it from sliding about
and to maintain precise operation.
Selecting a Good Location
(1) The workbench should have a flat surface.
(2) Avoid a location with direct sunshine, heavy moisture or dust.
Mounting Instructions
(1) Drill 4 locating holes through the workbench to match the holes in the
machine’s base. (Be sure to provide adequate clearance for the movement
of the Y-axis handwheel.)
(2) Use metal shims to level the machine and attach to the workbench with appropriate
size bolts, washers and nuts.
2.2 Check the Following Before Switching on the Machine
To avoid personal injury, please assure the following:
1.
Remove all tools used to mount the machine to your workbench.
2.
Check that the line power matches the machine requirements (see label on front of machine).
3.
Remove all stray objects in the vicinity of the machine.
4.
Remove anti-rust coatings.
5.
Check the tip angle of the column and tighten the column bolt.
6.
Make sure chuck, R8 shank and drawbar are mounted correctly and spin freely.
7.
Set speed (RPM) knob to OFF (fully counter-clockwise).
8.
Check operation of handwheels and feed screws for proper operation.
9.
During the test run, look for any faulty operation and make reparations before continuing with the
machine’s use.
CHAPTER 2 • MACHINE INSTALLATION