Page 14
optoCONTROL 1202
5.
Installation and Mounting
The measurement system optoCONTROL 1202 is an optical system for measurements with µm accuracy.
Make sure it is handled carefully when installing and operating.
5.1
Sensor Mounting
Mount the sensor only to the existing holes on a flat surface. Clamps of any kind are not permitted.
> Inaccurate, erroneous measuring values
Mount the transmitter and receiver above every the three through holes (dia. 4.5) or above every the two
tapped blind holes M5.
Bolt connection
Housing
Push through
length
Screw
Washer
Tightening torque
per screw
ISO 4762 - A2
ISO 7089 - A2
µ = 0.12
mm
Nm
ODC1202-75-T
30
M4
A4.3
2
ODC1202-75-R
30
M4
A4.3
2
ODC1202-100-T
30
M4
A4.3
2
ODC1202-100-R
30
M4
A4.3
2
