Page 75
Appendix | Operating Menu
optoCONTROL 2600
A 5.5 Selecting the Measurement Program
2
1
0
0
program: EDGEHL
Standard edge
bright - dark
2
0
0
0
select
program
2
2
0
0
program: EDGELH
Standard edge
dark - bright
2
3
0
0
program: DIA
Standard width
diameter
ESC
2
4
0
0
program: GAP
Standard gap
2
5
0
0
program: SEG_2_4
Standard segment
Edge 2 - 4
2
A
0
0
Name: Test0004
Measurement progr.
USER4
2
6
0
0
Name: MULTISEG
Standard multi-
Segment
+18,123
Main menu
Push the Enter button
for more than 3 sec.
Push the Down button
Push the Enter button
Select
measurement
program
2
0
0
0
1
0
0
0
Push the Enter button
2
1
0
0
Name: EDGEHL
Standard edge
bright dark
Choose a measure-
ment program
Push the Enter button
2
0
0
0
Select
measurement
program
ESC
Push the ESC button
1
0
0
0
Main menu
ESC
0
0
0
0
Save option?
Yes = Enter
No = ESC
Push the Enter button,
to save the settings.
Example to select
a measurement program
Fig. 70 Operating
Selecting the Measurement Program
The parameters which can be selected in the options are read out of the option data in the main memory and written
back. The user can decide only on quitting the main menu whether the parameters are to be written into the flash
memory. The data is then also present after
Power ON
.
The option data located in the main memory is used for the measurement mode. The currently set parameter appears
first during selection.
A maximum of four user programs can be saved. They can be overwritten.
The factory setting for the measurement program is the standard light-dark edge.
Measurement program: 2100
Program name: EDGEHL
Summary of Contents for ODC 2600-40
Page 81: ......
