Page 39
Operation
optoNCDT 1220
6.3
Timing, Measurement Value Flux
The sensor requires three cycles for measurement and calculation without triggering:
Each cycle takes 1000 µs at a measuring rate of 1 kHz. The measured value N is available at the output after
three cycles. The delay between acquisition and output is therefore 3000 µs. As the processing in the cycles
occurs parallel, after another 1000 µs, the next measured value (N+1) is output.
Summary of Contents for ILD 1220-10
Page 8: ...optoNCDT 2300...
Page 93: ......
