Condumax II Transportable
Sampling System User’s Manual
Michell Instruments
3
INTRODUCTION
The gas handling components are as follows:
Coalescing Filter (
F1
)
Provides protection of the moisture sensor within the
Condumax II instrument.
Pressure Gauge (
PG1
)
Provides indication of sample gas inlet pressure.
Pressure Regulator (
PR1
)
Allows the user to manually set the sample gas analysis
pressure for hydrocarbon dew-point measurement.
Non-return valve (
NRV1
)
Provides system protection from back pressure of vent
gas when sample gas is not flowing.
Metering Valve (
MV1
)
Allows the user to manually set the sample gas flow rate
across the dew-point sensors.
Flowmeter (
FM1
)
Provides indication of the sample gas flow rate across
the dew-point sensors.
Needle Valve (
NV1
)
Allows the user to manually control the bypass flow rate
across the coalescing filter.
Sample inlet
Sample outlet
FM1
MV1
NRV1
Filter Bypass/
Drain outlet
PR1
PG1
F1
NV1
AC Power
gland entry
PR1 Adjustment -
Remove cap. Adjust with 4mm
hex key.
Figure 2
Components
There is an option to add an ‘OUTPUTS’ junction box within the enclosure, allowing the
signals from the Condumax to be used externally
Summary of Contents for Condumax II
Page 28: ...http www michell com ...
