BIO TURBO 300
Toll Free in North America:
1-800-933-6478
www.miatech.org
8AM-5PM PacificTime:
1-503-659-5680
June 2010
THE ADVANTAGE COUNTS
Next, Separate the Catalytic Converter from the
Controller by unlatching the two latches and lifting the
Catalytic Converter causing the hinges to separate.
Lay the Catalytic Converter down so the opening is
facing upward. Get the plastic bag of catalyst and
carefully pour it into the opening on the Catalytic
Converter. See picture 4.
The converter can now be attached to the Reaction
Chamber with four small nuts (same setup procedure
like with Generation Chamber placing, described
above).
Mount the Controller box by sliding the hinges
together and latching the two latches. See picture 5.
Connect the remote cable by screwing the connector
of the remote to the connector on the Controller. See
picture 6.
Route the remote to the desired location. Plug the
two short power cords together and plug the long
power cord into the power receptacle. See picture
7.
Operation
Upon plugging the power cord into the power
receptacle, two LED's should be glowing green on
the controller. This tells us that power is to the
Controller and the circuit breaker is good.
Turn on the power switch. Two more LED's on the
Controller should come "ON". These indicate there is
power to the power transformer and there is power
to the fan.
There is also an LED on the Generation Chamber
which should be "ON" and also a low hum can be
detected indicating everything is operational.
Picture 4
Picture 5
Picture 6
Picture 7
