Installation Instructions
1.
Ensure that the vehicle is on a level surface in “Park” & with the hand brake engaged.
2.
Disconnect the car’s battery or ensure that the work area is well grounded.
3.
Unplug any wires which may be attached / harnessed to the underside of the vehicle’s seat. Proceed to unbolt
the seat from the vehicle’s floor.
4.
Carefully remove the seat out of the vehicle to allow for easier access to the vehicle’s seat & seat cover trim
“J” clips.
5.
Carefully remove the seat covers off of the seat by detaching the “J” clips which bind the Backrest Cover
together. Then, detach the clips which secure the seat bottom seat cover. These clips secure the cover at the base /
perimeter at the bottom of the seat.
6.
Place the heating pad & the seat bottom heating pad against the respective backrest & seat bottom. Align the
heating pads against the seat & “Mark” the listing attachment area to be cut to allow for the re-installation of the
backrest & Cushion covers.
7.
If required, carefully cut no more than 2 holes horizontally or 2 holes vertically from each of the seat heater
pads. The diameter of the each hole should not exceed 1 inch.
Note: The seat heater pads may also be trimmed in length to accommodate a variety of seating styles & listing
locations.
Example – If the seat bottom pad length is too long then simply trim the heating pad with a pair of scissors to
achieve the desired length .
Do Not: Cut the heating pads widthwise!!! This will render the seat heater useless and void the warranty.
8.
Remove the protective backing from the back side of the seat heating pad and carefully adhere the pad to the
seat at the desired location.
9.
At this point the holes cut in the pad should align with your identified key listing attachment locations.
Note: Older style listings = wire rod and listing sleeve (requires hog rings for the installation). Newer
style listings incorporate Velcro attachments. For older styles listings secure one of the provided
strips of adhesive tape around the wire listing rod to insulate it.
10.
Locate an onboard power source that is able to deliver a continuous 10 Amp current. This source may be
located at your accessory panel, accessory outlet, etc. Consult with the Owner’s Vehicle Manual to ensure an
appropriate location as a source of power source.
11.
Once the power source is located extend the wiring harness underneath the carpeting to be able to access this
power source. (Never install the wire directly under where the occupant’s feet would rest)
12.
Find a suitable location for your seat heater switches either at the side of the seat, front dash or floor mounted
center console in between the driver and passenger seats.
13.
At the desired location drill a 13/16” or 21mm hole and pull the main wiring connector to be attached to the
seat heater switch harness connector through the hole. Attach the switch connector with the main wiring
connector and push everything back through the hole and make sure to push the switch snuggly into the hole until
you hear a “click”.
5
