Prodomus
14
Do not wind the cable around the appliance.
Never store the cable before the appliance has cooled down completely.
Never use metallic or sharp edged cleaning material or sharp cleaning solvents while cleaning.
Scope of delivery
Water kettle EW 3662T
Base station with integrated cord
Instructions for use
Before the first use
Remove all packaging material as carton and foils.
Unroll the cord completely.
Place the unit on a stable, dry non-slip and heat resistant surface.
Clean the stainless steel surface with a slightly damp cloth and dry thoroughly.
Sometimes little smell might occure before use. If necessary boil some water empty and
rinse the water kettle afterwards to remove production residues that might be inside.
Repeat 1 - 2 times). Always take care not to let water run into the electric parts of the unit.
After filling water in order to clean, close the lid properly.
Connect the appliance to the current. Turn the temperature switch clockwise to MAX
position. Switch on. Repeat cleaning 2 times. Empty the water kettle completely.
Switch off (MIN position) after this process and unplug.
Open the lid and let the unit cool down.
Wipe the surface with a slightly damp cloth to remove stain due to water spotting.
H
H
o
o
w
w
t
t
o
o
u
u
s
s
e
e
t
t
h
h
e
e
w
w
a
a
t
t
e
e
r
r
k
k
e
e
t
t
t
t
l
l
e
e
Two different boiling-up modes of operation are available
Instant boil mode
In order to fill in water,
always
lift off the reservoir from the base station.
Use cold, fresh water only to fill the water kettle. Open the lid and fill the reservoir with
fresh water. The quantity of water filled in has to be between MIN and MAX at the inside
located water level scale – don't exceed or under-run.
Close the lid carefully until locked. The automatic switch-off works only with a properly
closed lid.
Put the kettle on its base station and switch-on the appliance by pressing the
ON/OFF
switch to I
(Thermostat on MAX position!)
The pilot lamp goes on.
The kettle switches off automatically some seconds after the water has started to boil.
Manual switch-off is possible at any time by touching the soft-touch switch. The soft-touch
switch needs no hard push. Touch it softly in order to avoid damages.
