5. Battery Installation (Remote Control)
Place batteries as shown in this image:
Attention:
1. Place batteries according to the
order of the polarity.
2. Never combine used and brand
new batteries.
3. Do not place different brands of
batteries into the remote
simultaneously
.
6.
Charging the Battery (Helicopter)
To charge the battery of the helicopter:
1.
Turn the switch in the helicopter “ON”.
2.
Connect the battery charger.
3.
Connect the charger to the electrical contact, the power indicator (red) will light up and
change to green when the battery is fully charged.
Caution:
1.
Make sure the charger is connected to the outlet.
2.
The battery can be damaged by overheating or over charging, please disconnect if the charger
is overheating.
3.
Do not leave the battery unsupervised when charging.
4.
The charger has an advanced and specific functioning system. For safety do not use other
chargers.
5.
Recharge the battery of the helicopter after 30 minutes of last flight has passed. Battery
temperature is high after flights, charging immediately after usage may cause damage to the
battery.
6.
For safety do not place the battery near heat sources that may cause short circuit.
7.
For security prevents binding of the terminals of the battery and leave them in contact with
metal parts that could cause a short circuit.
Summary of Contents for Lutema MIT35RMHB
Page 1: ......