6
p I c k u p I n s t a l l a t I o n
The Mi-Si CUTLESS System includes the L.R. Baggs Element Pickup. This flexible under-saddle piezo pickup
provides superb response and is easy to install.
Note:
For optimum performance of the Element pickup, the bridge slot must have a clean, flat
surface free of any debris or over-spray from the finish.
The slot must be a minimum of .125” (1/8”) deep, but we suggest a depth of at least .187” (3/16”) to avoid
excessive saddle tilt.
Follow The 50/50 Rule:
The amount of saddle visible above the bridge surface (with the pickup
installed) should be no greater than the amount of saddle in the slot beneath the bridge surface;
otherwise the balance and output of the pickup may suffer.
Inspect the inside of the guitar and note the position of the braces and the pickup in relation to the saddle
slot. Drill at the end of the slot on the side that will enable you to avoid all braces as you penetrate the top
(FIGURE 4)
. Blow out the slot with compressed air and check for remaining debris.
Important:
Round out the inside of the hole where it meets the bottom of the slot with a small,
sharp knife or a small file to avoid pinching the pickup as the saddle sits on it.
Feed the pickup into the slot from inside the guitar with either side up. Inserting a toothpick or similar
object through the hole from the outside is helpful in finding the location of the hole inside the guitar.
Important:
The fit of the saddle in the slot is the single most important factor in this installation.
It is crucial that the bottom of the slot and the lower surface of the saddle be flat and make even
contact with the pickup. The saddle should fit loosely enough so that it can be pulled out with your
fingertips.
7
p I c k u p I n s t a l l a t I o n
Extension
Drill Bit
Figure 1
Figure 2
Normal Saddle: Drill Floor
Figure 3
Short Saddle: Drill Side Wall
Jewelers’ Screwdriver
