MHS Boilers ELCO GENUS PREMIUM HP 100, Operating & Maintenance Manual, Page: 15 / 53

ELCO Genus Wall Mounted Condensing Boiler L352
15 27/03/2013 ©MHS Boilers
Minimum clearances
In order to allow easy access for boiler maintenance operations, installation distance must be
suitable.
Position the boiler according to the established technical rules, using a spirit level.
Gas connection
The boiler was designed to use gases belonging to the categories as shown in the following table.
Make sure, using the labels on the packaging and the data plate on the appliance itself, that the
boiler is in the correct country and that the gas category for which the boiler was designed
corresponds to one of the categories available in the country where it will be used. The gas supply
piping must be created and measured out in compliance with specific legal requirements and in
accordance with the maximum power of the boiler; you should also make sure that the shut-off
valve is the right size and that it is connected correctly. Before carrying out the installation, it is
recommended that the fuel pipes are cleaned thoroughly in order to remove any residues which
could prevent the boiler from operating correctly. Check that the supplied gas corresponds to the
type of gas for which the boiler was designed (see the data plate located on the appliance itself).
It is also important to check that the pressure of the gas (methane or LPG) you will be using to
feed the boiler is suitable, because if it is insufficient the power of the generator may be reduced,
causing inconvenience for the user.
COUNTRY MODEL CATEGORIES
UK
Genus Premium HP 45
Genus Premium HP 65
Genus Premium HP 85
Genus Premium HP 100
II2H3P