MHP MHPLX26G Owner'S Manual Download Page 5

GAS SAFETY REQUIREMENTS 

LP GAS HOOK-UP 

• A dented or rusty LP tank may be hazardous and should be checked by your LP Supplier. Never use a cylinder with a damaged valv

e. Cylinder 

dimensions should be approximately 12 inches in diameter and 18 inches high. The LP cylinder must be constructed and marked in accordance 

with the specifications for LP Gas Cylinders of the US Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339, 

Cylinders, Spheres and Tubes for Transportation of Dangerous Goods. 

Only Worthington, Manchester, or Wolfdale brand cylinders should be 

used with this appliance. 

 

• The propane gas cylinder valve must be equipped with a cylinder connection coupling device, described as Type 1 in the Harmoni

zed ANSI stan-

dard ANSIZ 21.58 and CGA 1.6-M95-1995 with addenda Z 21.58. This device is commonly described as an 

Acme Thread Quick Coupler 

(see 

Fig. 1 below). The gas must be turned off at the supply cylinder when the unit is not in use. If the appliance is stored indoors the cylinder must be 

disconnected and removed from the appliance. Cylinders must be stored outdoors in a well ventilated area out of reach of children. 

 

• The cylinder supply system must be arranged for vapor withdrawal and must include a collar to protect the cylinder valve. Disc

onnected cylinders 

must not be stored in a building, garage, or any other enclosed area. The grill is designed to operate on Propane gas regulated at a gas pressure 

of 10” water column (W.C.) (2.7kPa). A regulator adjusted to this pressure must be installed in the gas supply line before th

e grill is connected to 

the propane source. Use only the type regulator and hose specified by ProFire. 

 

NOTE: Hose and Regulator is preassembled to the grill valve at the factory. 

 

• Only 20 lb. cylinders equipped with an OPD (Overfill Protection Device) should be used with your MHP Grill. Only one propane c

ylinder may be 

located in an enclosure or cart. Extra spare cylinders must be stored outdoors out of the reach of children and outside of any building, garage or 
other enclosed area. 

Read and Follow All Warnings Provided with Propane Cylinders

. Never locate a cylinder under or near the barbecue 

unless sufficient ventilation and shielding is provided to prevent any heating of the cylinder, regulator and hose. 

Do not turn gas valve on unless connection between regu-

lator and tank is complete. Before attempting to light grill, 
be certain the gas valve knobs are in the “OFF” position, 

turn tank on by turning knob on top of the tank counter-
clockwise, check all connections for leaks by spraying or 
brushing a solution of 50% liquid soap and 50% water. If 

bubbles appear there is a leak, turn off gas and have a 
certified gas installer repair the leak. 

Type 1 Acme Thread Quick Coupler 

Cylinder 

Regulator 

Hose 

Hand Nut  With  

Acme Thread 

Hand Wheel 

QCC-1 

Fitting 

Valve 

LEAK TEST-CAUTION BEFORE TESTING

 

• NEVER USE THE GRILL WITHOUT FIRST LEAK TESTING THE GAS CONNECTIONS. 

• WARNING: DO NOT USE OPEN FLAME TO CHECK FOR LEAKS. USE OF AN OPEN FLAME COULD RESULT IN A FIRE, EXPLOSION AND  BODILY HARM. 

• DO NOT SMOKE WHILE PERFORMING THE LEAK TEST! 

• To prevent fire or explosion hazard, DO NOT use or permit sources of ignition in the area while performing a leak test. Perfor

m leak test outdoors only. 

• Check to ensure that flexible hoses do not have any cuts and wear that may affect the safety before each use. Only the factory

 supplied hose and regulator must be    

  used. Use only replacement regulator and hose assemblies specified by MHP Grills.  

 

 

1. Prepare a leak testing solution of sudsy water by mixing in a spray bottle with half liquid soap and half water. 

2. Confirm that all control knobs are in the 

“OFF” 

position. 

3. Turn the main gas valve supply 

“ON”

 

4. Apply leak testing solution by spraying on the pipe joints, fittings and hose. 

5. A gas leak is detected if: A) there is a faint gas smell and/or B) growing bubbles appear on any of the connection points and/or hose, 

DO NOT 

 

   attempt to ignite the grill and 

IMMEDIATELY

 turn off the gas supply valve. 

6. When there is a gas leak, call a qualified service technician. 

DO NOT 

use the grill until the leak is corrected. 

 

LEAK TEST 

Summary of Contents for MHPLX26G

















Reviews: