MHP JNR4, Owner'S Manual

Page: 10 / 40

Mountings
Stainless Steel and Aluminum Column
Assembly Instructions

All MHP Grill Heads may be mounted on the
Column.

The gas supply may be either LP or Natural.

The grill head should not be attached to the Col-
umn until the console is completely assembled.

The Column comes in two cartons — Box A con-
tains the console and all associated hardware. Box
B contains either the pedestal or cart base and all
base hardware.
Please check to be sure that all parts are included before pro-
ceeding. Contact your dealer if any parts are missing.
Parts Quantity
BOX A
Stainless Steel Front Panel 1
Stainless Steel or Aluminum Column 1
Stainless Grease Cup 1
Tank Lock Bar 1
Hardware Kit
Nylon Lock Bar Spacers 2
¼ - 20x1¼" S.S. Hex Head Bolts 4
¼ - 20 S.S. KEP Nuts 12
¼ S. S. Washers 10
¼ - 20 x ¾" S.S. Hex Bolts 8
Rectangular Washers (
Aluminum Column Only)
4
2-piece Gasket
(Stainless Steel Column Only)
1
Aluminum Reinforcing Bar
(Aluminum Column Only)
2
BOX B
Cast Aluminum Base 1
Stainless Steel Flexible Tubing, 28”
(OPN Only)
1
12’ Nat. Gas Hose/Quick Discount
(OCN Only)
1
Axle
(OCN or OCP Only)
1
Axle Clips
(OCN or OCP Only)
2
6 " Wheels
(OCN or OCP Only)
2
Hub Caps
(OCN or OCP Only)
2
Step 1: Connect the Tank Locking Bar
(Fig. 10)
1. From box “A” locate and attach the Tank Lock Bar across the
back of the pedestal column. Use the ¾" S.S. Hex bolt, Nylon
Lock Bar Spacer and a Kep nut on each side to fasten the
Tank Lock Bar in place. This spreads and holds the correct
spacing at the back of the column
.
Step 2: Attach the Base to the Pedestal
(Fig. 11)
1. Before bolting the pedestal column to the base, the 2-piece
gasket
(stainless steel column only)
must be installed to create a
barrier between the two metals. Remove the backing strips
from the gasket to expose the adhesive and stick the gasket
to the bottom lip of the pedestal column.
Make sure to align
the holes.
2. Attaching the pedestal column to the base will be easier to
handle by laying the pedestal column face down and match-
ing the holes on the pedestal column lip to the holes on the
base. Use six ¾” bolts, six stainless steel washers ( stainless
column) or four large rectangular washers ( aluminum col-
umn ), and on the underside six round washers and KEP nuts.
3. IMPORTANT : the large rectangular washers are used at the
sides on top of the pedestal column lip. The round washers
and KEP nuts are used under the base. Tighten securely and
stand unit upright.
Note: While assembling, peel the thin white protective film covering from
the stainless steel surfaces, especially in areas which will be partially
hidden after assembled.
Do Not Scrape off.
10
( Gasket for Stainless Only)
( Rect. for Aluminum Only)
(Round washers for stainless)