Mhouse WG10SK, Installation Instructions And Warnings, And User Manual, Page: 8 / 36

6 – English
English
INSTALLATION: ASSEMBLY AND CONNECTION OF COMPONENTS
––– STEP 5 –––
WARNINGS
• Incorrect installation may cause serious physical injury to those
working on or using the system.
• Before starting automation assembly, make the preliminary checks
as described in STEP 3
.
5.1 - INSTALLING THE GEARMOTOR WG10SK
To secure the gearmotor, proceed as follows:
01. Select the fixing position, observing the specifications in paragraph
3.1 “Preliminary checks”;
02. Ensure that the fixing surface is perfectly smooth, level and sufficient-
ly compact. WG10SK is not supplied with fixing devices, which must
be chosen also on the basis of the fixing surface material.
03. Lay the duct for routing the electric cable ( fig. 8 );
04. To construct the rear supports, assemble the two brackets and rear
plate as shown in
fig. 9 ;
05. the brackets and rear plate can be assembled in different ways: to
IMPORTANT!
- The following assembly phases show installation of a gearmotor
model WG10SK.
- To ensure correct system operation, mechanical stops must be
mounted on the floor or wall at the maximum leaf opening and closing
points.
Note - These stops are not supplied in the pack and are not
part of the Mhouse product range.
obtain the various values of “C” see fig. 10 ;
06. To construct the front support, assemble the bracket and front plate
as shown in fig. 11 ;
07. Remove the rear cover of the gearmotors pulling it out in the direction
of the arrows (
fig. 12 );
08. Move the leafs to the closed position;
09. With reference to the previously calculated position “B” ( fig. 4 and 5 ),
place the rear support on the fixing surface, in the envisaged position;
Caution! - check the positions in fig. 15.
10. Trace the drilling points of the rear support using the support as a ref-
erence Using a drill make four holes on the surface for insertion of 4
plugs of at least 8 mm (not supplied). Fix the plate with suitable
screws and washers (
fig. 13 );
11. Ensure that the plate is perfectly level (the slots on the bracket enable
small corrections to alignment, as shown in
fig. 14 );
12. Place the front support as shown in fig. 15 ;
13. Provisionally secure the front support to the leaf with a clamp (fig.
16) ;
14. Lift the gearmotor and insert the fork in the hole of the front support;
15. Keeping the gearmotor raised, pull to open the leaf and align the hole
on the rear plate with the hole on the gearmotor. Fix the gearmotor to
the rear support
[A] using screw [B] , nut [C] and washer [D] ( fig. 17 );
16. Tighten the nut fully down then loosen by approx. half a turn to
enable rotation of the gearmotor on its support;
17. Secure the gearmotor to the front support, tightening the screw [E]
and washer [F] , then tighten the screw fully down ( fig. 18 );
18. Unlock the gearmotor again using the release keys (see paragraph
11.3 - User’s Guide );
6
a
e f h
b c d
g
c
g
f
e
7
A
D
B C E D F D
G G