ASSEMBLY INSTRUCTIONS THERMOSTATIC SHOWER CB437
2/2
ASSEMBLY OF TUB FILLER
(FIG 6)
- Fully push spout block (I) into connection (C’) taking care of not damaging O-Ring gaskets.
- Tighten the assembly through ring (I’).
- Tighten flexible hose (L) to (L’).
UPPER COLUMN ASSEMBLY
(FIG 7) (FIG 7/a)
- Assemble tube (M) with (N) and screw onto block (I) (FIG 6)
- Insert flexible hose into the hole of bracket (T) and place bracket onto socket (T1).
- Check that I-M-N are in correct vertical position and then fix block (U) to the wall.
- Tighten two screws (V) with allen key N° 3 (enclosed).
ASSEMBLY OF SHOWER HEAD CURVE
(FIG 8) ( FIG 8/a)
- Unscrew and remove part (Q) from the end of flexible hose (L).
- Disassemble swivel head from shower curve (P) unscrewing (O’).
- Unscrew and remove part (O2).
- Insert shower curve (P) into upper column (N) without damaging the gaskets.
- Pull out flexible hose (L) from point (Q’) and fully push curve (P) into column (N).
- Screw back into position part (Q) to flexible hose (L) and fully push into (Q1).
- Screw back into position part (O2) and (O1).
