12
Your model has been equipped with fail safe battery connection,
so the unit will not move when you plug the battery in. Your unit
will only start once the speed control is switched on.
5.0 Battery Lead Fuse
Your battery has a 40amp fuse connected to the battery lead.
The 40 amp fuse helps protect the models control board against
a power surge. An extra fuse is supplied with your model.
In the unlikelihood of your unit stopping, the reason could be the
fuse has blown. Replacing the fuse is simple.
The fuse is located on the positive lead close to the battery
terminal.
To replace the fuse, simply open the case and remove the
existing fuse with a pair of pliers. Insert the new fuse ensuring the
two feet are guided into their sleeves. Refit the fuse cap.
6.0 Front Wheels
6.1 Removing the Front Wheels
The front wheels can be removed by pressing the blue button
shown in the picture and pulling the wheel down until it is
completely removed from the model.
6.2 Adjusting and Aligning the Front Wheels
Each unit is checked for straight tracking prior to leaving the
factory. In the unlikely event the MGI Navigator Quad Gyro is
not tracking straight, the front wheels can be adjusted to regain
straight tracking as follows;
1. Start the unit using the manual controls on a straight, flat
path. Do not start using the remote otherwise the Navigation
system will start. Watch the unit to see if it veers left or right
2. Now turn the wheel you want to adjust until you see the two
adjusting bolts in the front wheel as per the below picture.
3. If the unit veers left, use the 4mm Allen Key provided in the
Quad free spare parts to screw the right bolts (in both front
wheels) clockwise and/or the left bolts (as shown in below
picture) anti clockwise.
4. If the unit veers right, use the 4mm Allen Key provided in the
Quad free spare parts to screw the right bolts (in both front
wheels) anti clockwise and/or the left bolts (as shown in
below picture) clockwise.
Please note that there is a process in adjusting the track as above
point 3 and 4. It is suggested that the users should do a little bit of
adjustment, test the tracking and then adjust again until the unit
goes straight. After the unit tracks straight, do not swap the left
and right front wheels.
Step 2:
Plug the battery into the
model as shown.
Right Bolt
Left Bolt
MGI Navigator™ Quad Gyro
User Manual
13
Summary of Contents for NAVIGATOR QUAD GYRO
Page 1: ...User Manual VERSION 1 2 ...
