MGI JETVARNISH 3DS, User Manual

Page: 82 / 176

JETVARNISH 3DS 9. How to use the 3DSHM
User Manual - 82 -
[16] Feeder tab:
Click on this tab or on the feeder part on the machine
diagram to go on feeder setting tab.
(Refer to Chapter 9.3.5.3 Feeder tab)
[17] Printer tab:
Click on this tab or on the printer part on the machine
diagram to go on printer setting tab.
(Refer to Chapter 9.3.5.4 Printer tab)
[18] Curing tab:
Click on this tab or on the curing part on the machine
diagram to go on curing setting tab.
(Refer to Chapter 9.3.5.5 Curing tab)
9.3.5.3 Feeder tab
[19] Margin table
speed:
Change the value to adjust the speed of the margin
table. This value is a relative speed.
0% means that the margin table belt goes at the same
speed than the printing belt.
A negative value means that the margin table belt goes
slower than the printing belt.
Be careful to avoid positive value to prevent against
registration and jam issues.
[20] Drum speed:
Change the value to adjust the speed of the vacuum
drum. This value is a relative speed.
0% means that the vacuum drum goes at the same
speed than the margin table.
A negative value means that the vacuum drum goes
slower than the margin table.
[21] Double sheet:
The double sheet sensor (located between the feeder
plate and the cleaning unit) can be deactivated.
It is useful for some substrate due to their
manufacturing. the structure of the substrate itself or the
coating process. The surface is flat but air bubbles can
be inside the substrate.
[21]
[19]
[20]