6
3. Specification
Power source: 12V DC Battery or the supplied 12V DC mains adapter. If using the mains
adapter supplied with this energizer, the energiser must be installed out of the weather.
Maximum output Voltage up to 9 KV
Voltage under 500 ohm load up to 5.2 KV
Stored energy
1.8 J
Delivered Energy
1.0 J
Unless otherwise stated values are typical and normal production tolerances of ±10%
should be allowed for
4. Installation guide
Positioning the energizer
Install the energizer:
Adjacent to the electric fence in an upright position if powering from a 12V DC battery
Where a good earth can be obtained. A shady spot is better for an earth where the ground
is damper.
On firm ground away from flooding and out of reach of animals and children (inside a
protective fence, if required). If charging the battery using a solar panel, the solar panel
should face true north in the southern hemisphere and true south in the northern
hemisphere, positioned to get the maximum all day sun.
Mounting the energizer
The energizer can be mounted directly onto a wooden post using appropriate screws to fit
the slots on the rear of the energiser
Connecting to an electric fence
1 Push a 1m to 2m plated earth rod fully into firm ground. Must be plated as electricity will
not pass through rust.
2 Connect the black lead from the Fence earth terminal on the energizer to the earthing
system.
3 Connect the red lead from the Fence output terminal on the energizer to the fence.
Make sure there is a good contact.
Caution! Make sure the connecting leads drop downwards from the energizer to prevent
water from collecting at the terminals.
