This manual has been written according to following directives:
98/37/EEC, 2006/42/EEC, UNI-EN 10893
Art. 905650
Electric Test Pump
500bar
User Manual
rev. 1.1 dated 29/09/2015
Page 1: ...This manual has been written according to following directives 98 37 EEC 2006 42 EEC UNI EN 10893 Art 905650 Electric Test Pump 500bar User Manual rev 1 1 dated 29 09 2015 ...
Page 2: ...ump is used incorrectly for a purpose for which it was not intended or is tampered TECHNICAL ASSISTANCE MGF TOOLS For any technical assistance contact us in one of the following ways phone 39 0521 818301 fax 39 0521 818202 e mail assistenza mgftools com We will serve you in the shortest possible time Material being shipped for repair must be authorized by the RMA binding condition for the withdraw...
Page 3: ...and leave only it on the building site Don t leave the pump ON with TEST valve closed After a few minutes the bypass water increases temperature and this could damages gaskets Water temperature and air bubbles Water temperature and air bubbles can change pressure inside plant Consider these factors while testing big plants with big temperature differences High pressure water jets can cause damages...
Page 4: ...net is corresponding with data on the label Remember that long power cords may cause voltage losses Verify voltage at the pump plug The motor stops suddenly thermal protection has switched off the pump for too high temperature Check if voltage is correct if pump shaft isn t blocked or hard to turn Wait ten minutes then restart pump The motor don t start check electrical connections plug and switch...
