CONGRATULATIONS!
The tool you have purchased has been manufactured using
high end technologies and innovative materials. This sheet gives you important
informations about safety and to work at best possibilities with our pump. Keep this
sheet and read it carefully.
Purpose of use
Purpose of use
This electric pump is made to test plants and for liquid transplanting (see attached
table). We refuse every responsibility for every kind of damage caused by an
improper use of this pump.
Every modification to the machine isn’t allowed without
written permission of
MGF
MGF
s.r.l.
Power:
0,745 KW
Voltage:
230 V~
Frequency:
50 ~ 60 Hz
R.P.M.:
1400 RPM
Max flow rate:
17 l/min
Pressure:
20 bar
Weight:
17 Kg.
Tank:
12 l
Before Operating
Before Operating
(1) Before starting working, check if packaging isn’t damaged and that inside
there are all required optionals. Every machine has a label with a serial id
number and technical data.
(2) Check all working contidions and verify if they allows you to work in safe way
(lighting, humidity, temperature, wind…).
(3) Before connecting to the mains, check that electrical requirements reported
on the label are satisfied by the mains same. Connect to a plant equipped
with differential switch or similar safety devices. If you need to use long
power cords, ensure that the section of every wire is enough to draw all the
required power.
(4) Avoid every contact between electrical parts and water.
(5) Oil Level Check
(6) The pump is completely tested before shipping and so is full with oil. If
necessary, or after 500 work hours, fill oil tank up to level with 0,08 liters of
SAE 30 oil.
(7) WARNING: higher oil level will cause high pressures and stresses inside the
pump and, consequently, may damage the pump head.
(8) The suction hose mustn’t have bendings and inlet filter must be clean, in
order to reduce suction head and to let the pump to work in better
conditions.
(9) Avoid also air suction, that will cause pressure instability and can make
2
