2
2
3
QUICK START
•
Always turn the robot base “OFF” after playing to conserve battery life.
• DO NOT expose the robot base to moisture of any kind.
• Do not use stickers on humans, pets, furniture or any item which may be damaged by sticker
or sticker removal.
• Stickers may not be removable once applied to the can or can label.
IMPORTANT INFORMATION
• Use alkaline batteries for best performance and longer life.
• Use only
t
he type battery recommended for the unit.
• Batteries should be replaced only by an ad
ult.
• Insert batteries with the correct polarity ( + and – ).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable(nickel-cadmium) batteries.
• Do not short-circuit batteries.
• When not used for an extended time, remove batteries to prevent possible leakage
and damage to the unit.
• Do not mix rechargeable and non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before charging.
• Rechargeable batteries are to be recharged only
u
nder adult supervi
sion.
• Do not recharge non-rechargeable batteries.
• Exhausted batteries are to be removed from the toy.
• Do not dispose of batteries in fire as they may leak or explode.
SAFE BATTERY USAGE
1
2
3
4
1. Snap the two feet onto the robot
base with the points facing inward
as shown.
3. Place one front ring clamp and one
rear ring clamp around the can and
secure with screws. Repeat with
additional ring clamps.
4. Build your robot by attaching parts
to the can rim,adding accessories
to the openings on the clamps and
attaching eye stickers.
2. Peel the sticker label from its backing
and wrap it around the soda can.
5
5. Place the robot into the robot base.
6
6. Move the switch on the back of the
unit to the “ON” position to make
your robot walk!
screw
screw
ON
An adult must install fresh alkaline
batteries
(not included)
in the robot base
prior to playing. Here’s how:
1. Remove the feet from the robot base.
2. Using a Phillips screwdriver (not
included) remove the screw battery
compartment cover on the bottom of
the base.
3. Install two (2) 1.5V
AAA
(LR03) alkaline
batteries (not included) making sure
the (+) and (-) ends face the proper
direction as indicated inside the battery
compartment.
4. Replace the compartment cover and
tighten the screw.
BEFORE YOU BEGIN
2 x AAA Batteries
1.5V AAA/LR03
1.5V AAA/LR03
