BLOWING
Start the blower engine Hold the blower firmly about 10 - 20 cm from the ground and move it in a sweeping motion
from left to right, directing the debris to the desired location.
●
●
●
●
Use low throttle settings when clearing lightweight materials from around lawns or shrubbery.
●
●
●
●
Use medium to higher throttle settings to move lightweight grass or leaves from driveways or paths.
●
●
●
●
Use full throttle when moving heavy loads.
IMPORTANT.
Blower noise increases at higher throttle settings. Always use the lowest throttle setting required to
get the job done.
MAINTENANCE
BEFORE EACH USE:
●
●
●
●
Remove dirt and debris from the blower exterior.
●
●
●
●
Inspect the engine, tank and hoses for possible fuel leaks, and repair as necessary.
●
●
●
●
Inspect the engine cooling fins for accumulations of dirt or debris , and clean as necessary.
EVERY 10~15 HOURS OF USE
1, Loosen the air cleaner cover retaining screw, and remove the cover and filter element.
2, Inspect the element. If the element is distorted or damaged, replace it with a new one.
3, Wash the element in clean fuel, and squeeze or blow dry. Wash the air cleaner cover in clean fuel, and wipe or
blow dry.
4, Install the element and cover, and then tighten the cover retaining screw.
5, Use the spark plug wrench to remove the spark plug (turn counter-clockwise to remove)
6, Clean and adjust the spark plug gap to 0.6-0.7 mm. Replace any damaged or visibly worn plug with a L8RCT or
equivalent
7, Install the spark plug finger-tight in the cylinder head, then tighten it firmly with the spark plug wrench.
EVERY 50 HOURS OF USE
●
●
●
●
INSPECTION Inspect the entire blower and tubes for damage, including loose or missing component, and repair
as necessary.
●
●
●
●
SPARK PLUG Replace the spark plug with a L8RTC, gapped to (0.6-0.7) mm.
●
●
●
●
FUEL FILTER Use a wire hook to extract the fuel filter from inside the fuel tank, and then remove and wash the
filter element in clean fuel. Before reinstalling the filter, inspect the condition of the fuel line. If damage or
deterioration is noted, the blower should be removed from service until it can be inspected by a trained service
technician.
ADJUSTING ENGINE IDLE SPEED
From time to time it may be necessary to adjust the idle speed of the
motor for smooth running.
1. Start the engine.
2. Run the engine at idle speed until operating temperature is reached
usually (2-3 minutes)
3. Use a screwdriver to adjust the engine idle speed to (2800-3000) rpm.
