
4. Connect a short piece of RG-58U or RG-8U with PL-259 (use the
wattmeter patch cable if desired) to the Coax Antenna connector of
the MFJ-204B.
5. Hold one end of the coax patch cable close to the antenna input
of your transceiver. Do not make physical connection.
6. Tune the TUNE control on the MFJ-204B until the oscillator can
be heard on the receiver. Make note of this tune control. setting
on the
MFJ-204B. DO
NOT re-adjust.
7. Disconnect the patch cable.
8. Connect the antenna to your antenna tuner, then connect the MFJ204B
to the tuner.
9. Set the RESISTANCE control to 50 ohm.
10. Tune the antenna tuner until the meter of the MFJ-204B reads minimum 11.
Your antenna tuner is now set for 50 ohm at that frequency. 12. Disconnect
the MFJ-204B from the antenna tuner. Connect your
transceiver to the antenna tuner. Check the antenna tuner setting
for best SWR with a SWR meter. A slight retuning of the tuner may
be necessary to insure minimum SWR.
Summary of Contents for mfj-204b
Page 3: ...JI...