MFJ-493 Instruction Manual
12
Output Tune
(TU)
Use Output Tune to tune up your station. A constant key is sent to allow tuning of your tuner or
antenna.
Paddle
Squeeze the paddles to exit.
Keyboard
Press F11 to enable the output tune. Press Esc to exit.
Keyer Terminal
Type [co]TU to enable the output tune. Press Esc to exit.
Edit Message
(ED)
Use Edit message to change a message memory. Press the edit message button, the keyer will re-
spond with "ED". Enter the number of the message to edit 1 - 8 on you paddle, keyboard, or keyer
terminal. The keyer will begin playing the message. At any time during the message, press the
paddle or Esc key to begin editing. If you do not interrupt it the message will play to its end and
exit edit message mode.
When you interrupt the message you set an insertion point. You can do four things from an inser-
tion point. You can delete the last word, insert a word, end the message, or continue playing the
message by keying in "P".
To delete the last word played enter "D". The keyer will play the word before the word that was
deleted. Now you can delete another word, insert text, end the message, or continue playing the
message by entering "P".
To insert text enter "I". Enter your text. At the end of your text enter "+". The keyer will exit the
insert mode. Now you can delete a word, insert text, end the message, or continue playing the
message by keying in "P".
To end the message at your insertion point enter "+". The keyer will end the message and exit the
edit mode.
The edit feature is adequate for short messages where there are few changes. However, to edit a
large message, 100 - 4000 characters, the edit message mode is very impractical, if you use large
messages, edit your messages with an ASCII text editor and then upload them into a memory.
Paddle
Press the edit message button. The keyer will play "ED". Key in the memory number. The
keyer will begin playing your message. From command mode key in "E#"(# = 1 - 8). The
keyer will begin playing your message.
Keyboard & Keyer Terminal
Press the edit message button. The keyer will play "ED". Type in the memory number. The
keyer will begin playing your message. From command mode type in "E#"(# = 1 - 8). The
keyer will begin playing your message.
Summary of Contents for Memory Keyer MFJ-493
Page 1: ......
Page 26: ...MFJ 493 Instruction Manual 23 MFJ 493 Schematic...
