12
Print Head Cam Adjustment
The drawer must be in the out position when making this adjustment. If the drawer is not open,
run test one.
1.
If the printer is not in “Diagnostic Mode,” power on the printer while holding down the
Unit attention button for at least eight seconds.
2.
Press the Unit attention button five times to run test five. When you press the button for
the fifth time, hold the button down until the print head moves. See Figure 14.
Figure 14
1.
Press the Unit Attention button four times to run test four. This will raise the print head
to make sure the cam is in the correct position as shown in Figure 13.
2.
If the cam is in the correct position, go to “Cross Hatch Pattern Test” on page 14.
If the cam is not in the correct position, go to step 5.
