C
ompressed-air Stapling Plier
Z 23 P
Page:
20
Mod.:
01/2022
ET
Seite 20 von 34 31.01.22 P:\Technik\ZANGEN\Z 23 P\Bedienungsanleitung\Englisch\Manual Z 23 P Pneum en_01_2022.docx
13.4
Adjust vent
To adjust the exhaust vent, turn the adjuster (1) in the desired direction.
Turn the exhaust vent so that the exhaust air does not hit you or other persons.
13.5
Check functionality
To ensure trouble-free functionality of the stapling device, proceed as follows:
ATTENTION
Observe the Hazard Warnings in the “Safety” section,
Position a carton at least 16 mm thick in the opening between the anvil and discharge
opening.
Trigger the stapling device.
Check the following properties:
- Triggering occurs only when the trigger safety is pressed.
- One staples must be driven into the carton material for each pull of the trigger.
- Exhaust air must not blow towards the face.
To obtain the desired bending profile if needed, change the operating pressure, the bottom
retaining clip, or the carton thickness setting (see page
Fehler! Textmarke nicht definiert.
).
Repeat these steps as needed.
The stapling device is now ready for operation.
